Toshiba SD-4980 User Manual - Page 19

Connecting to an audio system and TV equipped with component video inputs - problems

Get Toshiba SD-4980 PDF manuals and user guides View all Toshiba SD-4980 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Interlaced outputs (ColorStream®) Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy higher quality picture playback. Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB, CR) In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In such a case, adjust the TV or monitor for optimum performance. Progressive outputs (ColorStream Pro®) Some TVs or monitors are equipped with component video inputs that are capable of reproducing a progressively scanned video signal. Connecting to these inputs allows you to view the highest quality pictures with less flicker. Consumers should note that not all high definition television sets are fully compatible with this product and may cause artifacts to be displayed in the picture. In case of 525 progressive scan picture problems, it is recommended that the user switch the connection to the "standard definition" output. If there are questions regarding our TV set compatibility with this model 525p DVD player, please contact our Customer Service Center. Connecting to an audio system and TV equipped with component video inputs Connections Switching the output signal (interlaced/progressive) using the remote control You can temporarily switch the output signal for better picture quality. Press PROGRESSIVE on the remote control during stop mode. Press PROGRESSIVE again to turn off progressive mode. • Make the following setting. On-screen display "Digital Output" Select: "PCM" or "Bitstream" Page 54 59 Notes "Video Output" Component 54 58 • Refer to the owner's manual of the connected equipment as well. • When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections. • If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD video player away from the tuner and radio. • The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening level. Otherwise, high volume sound may damage your hearing as well as the speakers. • Turn off the amplifier before you connect or disconnect the DVD video player's power cord. If you leave the amplifier power on, the speakers may be damaged. • Progressive can be on/off only when "Video Output" is set to Component 58 . • In component connections, the screen might become pinkish in color when the "Video Output" is set to Composite. This is not a defect of this unit 58 . • When Progressive is on, only component video will be output. • Analog audio out will not have sound if DTS playback is selected. • When using component video cables, do not connect the S video cable. ColorStream® and ColorStream Pro® are registered trademarks of Toshiba America Consumer Products, L.L.C. 19 p18-24-4980SU.pmd 19 6/10/2005, 10:31 AM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
19
Connections
Notes
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the
DVD video player away from the tuner and radio.
•The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate
listening level. Otherwise, high volume sound may damage your hearing as well as the speakers.
•Turn off the amplifier before you connect or disconnect the DVD video player’s power cord. If you leave the amplifier power
on, the speakers may be damaged.
• Progressive can be on/off only when “Video Output”
is set to Component
58
.
• In component connections, the screen might become pinkish in color when the “Video Output” is set to Composite. This is
not a defect of this unit
58
.
• When Progressive is on, only component video will be output.
• Analog audio out will not have sound if DTS playback is selected.
• When using component video cables, do not connect the S video cable.
Connecting to an audio system and TV equipped with component video inputs
Interlaced outputs (ColorStream
®
)
Some TVs or monitors are equipped with component video
inputs. Connecting to these inputs allows you to enjoy
higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y,
C
B
, C
R
)
In some TVs or monitors, the color levels of the playback
picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum
performance.
Progressive outputs (ColorStream Pro
®
)
Some TVs or monitors are equipped with component video
inputs that are capable of reproducing a progressively
scanned video signal.
Connecting to these inputs allows
you to view the highest quality pictures with less flicker.
Consumers should note that not all high definition
television sets are fully compatible with this product and
may cause artifacts to be displayed in the picture. In case
of 525 progressive scan picture problems, it is
recommended that the user switch the connection to the
“standard definition” output. If there are questions
regarding our TV set compatibility with this model 525p
DVD player, please contact our Customer Service Center.
Switching the output signal (interlaced/progressive)
using the remote control
You can temporarily switch the output signal for better picture
quality.
Press
PROGRESSIVE
on the remote control during stop mode.
Press
PROGRESSIVE
again to turn off progressive mode.
ColorStream
®
and ColorStream Pro
®
are registered trademarks of Toshiba America Consumer Products,
L.L.C.
•
Make the following setting.
On-screen display
Select:
Page
“PCM” or
“Bitstream”
“Digital Output”
Component
“Video Output”
54
59
54
58
p18-24-4980SU.pmd
6/10/2005, 10:31 AM
19