Toshiba SD-P7000 User Manual - Page 16

Connections External equipment connections (Continued) The connection cables are not supplied. VCR Setup Connection 1 Set VCR CH switch to 3 or 4 and then tune TV to the same channel number. Connection 2 1. Connect the audio/video output jacks on the VCR to the corresponding input jacks on the TV. When connecting the TV to a VCR, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red). 2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner's manual.) 3. Use the INPUT SELECT button on the remote control to select Video. (If connected to S-VIDEO on the side panel, select the S-Video external input source.) ANT IN 75 TV Back Panel Typical Antennas 1 2 TV Side Panel ANT OUT ANT IN S-VIDEO OUT CH3 IN CH4 VIDEO (R) AUDIO(L) VCR Cable TV Setup - After subscribing to a local cable TV service and installing a converter, you can watch cable TV programming. - For further cable TV information, contact your local cable service provider. Connection 1 1. Select channel 3 or 4 with the channel switch on the cable box. 2. Tune the TV channel to the same selected output channel ANT IN 75 of the cable box. 3. Select channels at the cable box or with the cable box remote control. Connection 2 1. Connect the audio/video output jacks on the Cable Box to the corresponding input jacks on the TV. When connecting the TV to the Cable Box, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red). 2. Use the INPUT SELECT button on the remote control to select Video. 3. Select channels using the cable box remote control. TV Back Panel 1 2 TV Side Panel TV RF Cable VCR VIDEO (R) AUDIO (L) Cable Box 16