Toshiba SD-V593 User Manual - Page 16
Antenna connections
View all Toshiba SD-V593 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Connections Antenna connections If you are using an antenna system, follow these instructions. If you are a Cable TV subscriber, skip ahead to page 16 for the proper connections. Antenna to DVD/VCR connection The DVD/VCR must be connected "between" the antenna and the TV. First, disconnect the antenna from the TV and connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an antenna system to a DVD/VCR. Find the type of antenna system you are using and follow the connection diagram. 1 Combination VHF/UHF Antenna with 75 ohm Coaxial Cable DVD/VCR 75 ohm Coaxial Cable IN (ANT) OUT (TV) 2 Combination VHF/UHF Antenna with 300 ohm Twin Lead (Flat) Wire DVD/VCR Matching Transformer 300 ohm Input 75 ohm output (not supplied) 300 ohm Twin Lead (Flat) Wire (not supplied) IN (ANT) OUT (TV) 3 Separate VHF and UHF Antennas VHF UHF Combiner 75/300 ohm Inputs 75 ohm output (not supplied) 300 ohm Twin Lead (Flat) Wire (not supplied) DVD/VCR IN (ANT) OUT (TV) 75 ohm Coaxial Cable Note: If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm inputs and one 75 ohm output. Notes: • A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the antenna to the DVD/VCR properly. • For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an outdoor type antenna is required. 16 • If you are not sure about the connection, please refer to qualified service personnel. 2F90201A (E)p16-28 16 4/4/05, 9:01 PM