Toshiba TDPMT200 Owners Manual - Page 32

Using the menu (Continued) ■ Displaying Information (Status display) This displays information about the input signal, lamp use time, etc. "Yes": displayed, "No": not displayed Item Description Computer Y/PB/PR Video S-video DVI Input Input source name Yes Yes Yes Yes Mode name RGB input mode [Note 1] Yes No No Yes H-resolution Horizontal resolution (in dots) Yes No No Yes V-resolution Vertical resolution (in dots) Yes No No Yes H-frequency Horizontal sync frequency Yes No No Yes V-frequency Vertical sync frequency [Note 2] Yes No No Yes Sync Sync signal polarity [Note 3] Yes No No Yes Signal format Y/PB/PR signal format No Yes No No Video mode Color method of video signal No No Yes No Lamp time Time of lamp use [Note 4] Yes Yes Yes Yes Lamp reset count The count for lamp replacement Yes Yes Yes Yes Total time The total time that this projector is used Yes Yes Yes Yes Version Firmware version [Note 5] Yes Yes Yes Yes Notes 1: The mode of supported RGB signals p.39 is shown. 2: Same as the refresh rate of the computer signal. 3: Sync signal polarity shown as P (positive) or N (negative) for [H/V]. 4: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult with a store about getting a TLPLMT20 replacement lamp (sold separately) prepared. 5: [Version] shows the version of the projector's internal control program. This version is referred to for customer service, etc. Note • The displayed information will not be refreshed if the status changes. To refresh the information, dismiss the display, then display it again. 32