Toshiba TLP-T401U LCD Projector TLP-T400/T500/T700 Users Guide (PDF) - Page 26

Using the document camera (Continued) I Storing the camera images into the memory PC card (Models equipped with PC card slot) Models equipped with a PC card slot are able to save image data taken with the document camera onto a memory PC card (sold separately) in JPEG format. 1 Mount a memory PC card into the PC card slot p.23 . Mounting a PC card will switch to PC card input if Input select mode is set to Auto on the PC card setting menu p.54 . In this case, press the CAMERA button on the Camera control panel to switch to camera input. 2 Display the camera image, and press the STORE IMAGE button. A message appears on the screen, confirming that you wish to save the image. W.BALANCE OVERLAY ARM LIGHT LOCK STORE IMAGE CAMERA GAIN CAMERA 3 Press the buttons to save the image. (To not save the image, use the buttons to select No, then press the button.) Data save to the memory PC card begins. The icon will appear on the upper left of the screen during saving. Never remove the memory PC card during a save. Doing so could corrupt your data, or damage the PC card. When the writing is complete, the icon disappears and a message appears informing you that saving is complete, then disappears after a few seconds. Repeat step 2 3 as necessary to store more images. 4 Check the saved file, if necessary. Use the steps in "Projecting images stored in a memory PC card" p.41 to check the contents of the file or image. Images are saved in the memory PC card's _doccam folder in JPEG format. If there is no _doccam folder, the images are created in the memory PC card's root directory. Notes • Any adjustments other than CAMERA GAIN (+/-) and Sharpness will not be reflected on a JPEG file saved on the memory PC card. • It is not possible to photograph resized or frozen images. • Saved files are saved with names in the range of pix001.jpg to pix999.jpg. If there is already a file named pix999.jpg, no more files can be saved. • The size of the file will vary, depending on the image. The number of files that can be saved depends on the size of the files and the capacity of the memory PC card. • Do not mount a write-protected memory PC card into the projector. It may become impossible to access the memory PC card. 50 Operating a computer using the remote control A computer can be operated using the projector's remote control. This function is available on any computer with the Windows 98/98SE, Windows Me, Windows 2000, or Windows XP OS, that is equipped with a USB port (The mouse remote control is not supported on OS 9 or OS X for the Macintosh). 1 Connecting a computer Connect the projector to a computer using the supplied USB cable. See Fig. (1) below. For models equipped with PC card slot, connect the supplied Mouse remote control receiver to the computer. See Fig. (2) below. (1) (2) To USB port To USB port USB MONITOR CONTROL 1 COMPUTER 2 ( Y,PB/PR ) Mouse remote control receiver 2 Operating a computer The mouse remote control function is available when the remote control is set to [PC Mode]. (See "Switching operation modes" p.20 .) Point the remote control at the infrared remote sensor (in models using Mouse remote control receivers, point it at the Mouse remote control receiver), and operate the remote control's buttons. G Moving the mouse pointer Move the pointer control button in the direction that you wish the mouse pointer to move, then press. G To left click Press the L-CLICK button. G To right click Press the R-CLICK button. G To drag and drop Move the pointer control button in a (L-)clicked state, then when the pointer is over the desired location, release the button. G Using the computer's up and down arrow key functions Press the and buttons to switch PowerPoint® slides. Remote Control Front Remote Control Rear Pointer control R-CLICK VOL.- VOL.+ PJ MODE MENU / ENTER R-CLICK INPUT LASER L-CLICK 51 Operations