Toshiba TLP-T401U LCD Projector TLP-T400/T500/T700 Users Guide (PDF) - Page 30

Lamp replacement (Continued) 3 Remove the lamp cover. Loosen the screws, then pull up to direction of 3 1 the arrow with your fingers on the area shown 2 in the figure to remove the lamp cover. Be careful to avoid breaking a nail or otherwise injuring your fingers when doing so. (If the screws are too tight to remove the lamp cover, Lamp cover use any tool.) 4 Pull out the lamp. Loosen the 2 screws holding the lamp in place, and pull on the handle to remove the lamp. 4 1 2 5 Mount the new lamp. Align the orientation, press down until the bottom is reached, and lock in place using the two lamp locking screws. 6 Replace the lamp cover. Align the cover, and press it in, then screw in the 2 5 1 screws loosened in step 3 until the lamp cover is no longer loose. 7 Reset the lamp timer. See the lamp's manual for instructions on resetting the lamp timer. Notes and Precautions • Press the button twice to display (a rough guide) of the time of use from the Lamp time item on the Status display menu. p.32 • As a rule of thumb, it is recommended that the lamp should be replaced after 2,000 hours of use. When Lamp time reaches 2,000 hours, the icon and a message will appear. When any operation is performed, the message disappears. • Attach the lamp cover correctly so that it is not loose. If it is not attached correctly, the lamp may fail to come on p.64 , and the lamp's lifetime may be shortened. • Always replace the lamp with a new one. • The lamp is made out of glass. Do not touch the glass surface with your bare hands, bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.) Used Lamps This projector's lamps contain trace amounts of environmentally harmful inorganic mercury. Be careful not to break used lamps, and dispose it in accordance with local regulations. 58 How to use the supplied software Please read this chapter if the model you purchased includes a PC card slot. This chapter briefly describes how to use supplied software applications other than the Wireless utility. I How to use the Projector Configuration Tool The Projector Configuration Tool is a software utility that allows you to set up the projector for Infrastructure mode communications using a wireless LAN PC card. When using this application for the first time, conduct Preparation p.34 , and start with the computer in Ad hoc transmission mode. 1 Check MAC address. The MAC address is a unique address assigned to the wireless LAN PC card. Display the MAC address on the screen, referring to "Displaying Information" p.32 . Note down the address for future use. 2 Launch the Projector Configuration Tool. Upon launch, the window shown in the figure to the right appears on the computer screen. 3 Click on the Browse button. The computer starts searching for projectors. When it finds one, "Please select" is displayed in the Projector Selection field. 4 Select a projector. Click on the button for the Projector Selection field, then from the pull-down list that is displayed, select the project with the MAC address you noted down in step 1 . When a projector is selected, the computer obtains information from that projector, and displays the results in the boxes of the window. Here, the following is possible: From the File menu, select Save As..., and save the pre-modification settings on the computer. From the File menu, select Open, and apply an existing settings file to the projector. 59 Others