Tripp Lite B097048INT Owners Manual for B093- B097- and B098-Series Console Se - Page 228
Connection Alert, Signal Alert, Pattern Match Alert, UPS Power Status Alert, myUPS, thatUPS,
View all Tripp Lite B097048INT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 228 highlights
14. Configuration from the Command Line Below are the specific settings, depending on the type of alert required: Connection Alert To trigger an alert when a user connects to serial port 5 or network host 3: # config -s config.alerts.alert2.host3='host name' # config -s config.alerts.alert2.port5=on # config -s config.alerts.alert2.sensor=temp # config -s config.alerts.alert2.signal=DSR # config -s config.alerts.alert2.type=login Signal Alert To trigger an alert when a signal changes state on port 1: # config -s config.alerts.alert2.port1=on # config -s config.alerts.alert2.sensor=temp # config -s config.alerts.alert2.signal=[ DSR | DCD | CTS ] # config -s config.alerts.alert2.type=signal Pattern Match Alert To trigger an alert if the regular expression '.*0.0% id' is found in serial port 10's character stream: # config -s "config.alerts.alert2.pattern=.*0.0% id" # config -s config.alerts.alert2.port10=on # config -s config.alerts.alert2.sensor=temp # config -s config.alerts.alert2.signal=DSR # config -s config.alerts.alert2.type=pattern UPS Power Status Alert To trigger an alert when myUPS (on localhost) or thatUPS (on remote host 192.168.0.50) power status changes between on-line, on-battery and low battery: # config -s config.alerts.alert2.sensor=temp # config -s config.alerts.alert2.signal=DSR # config -s config.alerts.alert2.type=ups # config -s config.alerts.alert2.ups1=myUPS@localhost # config -s [email protected] Environmental and Power Sensor Alert # config -s config.alerts.alert2.enviro.high.critical='critical value' # config -s config.alerts.alert2.enviro.high.warning='warning value' # config -s config.alerts.alert2.enviro.hysteresis='value' # config -s config.alerts.alert2.enviro.low.critical='critical value' # config -s config.alerts.alert2.enviro.low.warning='warning value' # config -s config.alerts.alert2.enviro1='Enviro sensor name' # config -s config.alerts.alert2.outlet#='RPCname'.outlet# 'alert2.outlet#' increments sequentially with each added outlet. The second 'outlet#' refers to the specific RPC power outlets. # config -s config.alerts.alert2.rpc#='RPC name' # config -s config.alerts.alert2.sensor=[ temp | humid | load | charge] # config -s config.alerts.alert2.signal=DSR # config -s config.alerts.alert2.type=enviro # config -s config.alerts.alert2.ups1='UPSname@hostname' Example 1: To configure a temperature sensor alert for a sensor called 'SensorInRoom42': # config -s config.alerts.alert2.sensor=temp # config -s config.alerts.alert2.enviro.high.critical=60 # config -s config.alerts.alert2.enviro.high.warning=50 # config -s config.alerts.alert2.enviro.hysteresis=2 # config -s config.alerts.alert2.enviro.low.critical=5 # config -s config.alerts.alert2.enviro.low.warning=10 # config -s config.alerts.alert2.enviro1=SensorInRoom42 # config -s config.alerts.alert2.signal=DSR # config -s config.alerts.alert2.type=enviro 228