Troy-Bilt Storm 2620 Operation Manual - Page 14

Auger Control Standard Chute Directional Control (if so equipped) T The auger control is located on the left handle. Squeeze the control grip against the handle to engage the augers and start snow throwing action. Release to stop. Drive Control / Auger Clutch Lock The chute directional control is located on left side of the snow thrower. To change the direction in which snow is thrown, rotate chute directional control. 2-Way Chute Directional Control (if so equipped) The drive control is located on the right handle. Squeeze the control grip against the handle to engage the wheel drive. Release to stop. The drive control also locks the auger control so that you can operate the chute directional control without interrupting the snow throwing process. If the auger control is engaged simultaneously with the drive control, the operator can release the auger control (on the left handle) and the augers will remain engaged. Release both controls to stop the augers and wheel drive. NOTE: Always release the drive control before changing speeds. Failure to do so will result in increased wear on your machine's drive system. Heated Grips (if so equipped) Caution: It is recommended that you wear gloves when using the heated grip. If the heated grip becomes too hot, turn it off. The 2-way chute directional control is located on the left side of the dash panel. • To change the direction in which snow is thrown, squeeze the button on the joy-stick and pivot the joy-stick to the right or to the left. To activate the heated grips, move the switch found on the rear of the dash panel into the ON position. To turn off the heated grips, move the switch found on the rear of the dash panel to the OFF position. 14 Section 4 - Controls and Features