Troy-Bilt Storm 2620 Operation Manual - Page 7

Assembly & Set-Up - snow

Get Troy-Bilt Storm 2620 PDF manuals and user guides View all Troy-Bilt Storm 2620 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Assembly & Set-Up 3 Contents of Carton • One Snow Thrower • One Snow Thrower Operator's Manual • One Engine Manual • Two Replacement Auger Shear Pins • One Chute Assembly (Model 2410) • One Product Registration Card • One Chute Control Rod (Models 2620, 2840 and 3090XP) Assembly Handle 1. Place the shift lever in the Forward-6 position. 2. Observe the lower rear area of the snow thrower to be sure both cables are aligned with roller guides before pivoting the handle upward. See Fig. 3-1. Figure 3-2 Chute Assembly (Model 2410) 1. Position the chute assembly over the base. See Fig. 3-3. Figure 3-1 NOTE: Make certain the cables are seated properly in the roller guides. See Fig. 3-2. 3. Secure the handle by tightening the plastic knob located on both the left and right sides of the handle. Remove and discard any rubber bands, if present. They are for packaging purposes only. Figure 3-3 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
Assembly
Handle
Place the shift lever in the Forward-6 position.
1.
Observe the lower rear area of the snow thrower to be sure
2.
both cables are aligned with roller guides before pivoting
the handle upward. See Fig. 3-1.
NOTE:
Make certain the cables are seated properly in the
roller guides. See Fig. 3-2.
Secure the handle by tightening the plastic knob located
3.
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
Chute Assembly (Model 2410)
Position the chute assembly over the base. See Fig. 3-3.
1.
Contents of Carton
One Snow Thrower
•
Two Replacement Auger Shear Pins
•
One Chute Assembly (Model 2410)
•
One Snow Thrower Operator’s
•
Manual
One Product Registration Card
•
One Chute Control Rod
•
(Models 2620, 2840 and 3090XP)
One Engine Manual
•
Figure 3-1
Figure 3-3
Figure 3-2
Assembly & Set-Up
3
7