Troy-Bilt Storm 2620 Operation Manual - Page 19

Chute Assembly Refer to the Assembly and Set-up section for instructions on adjusting the chute assembly. Skid Shoes Refer to the Assembly and Set-up section for instructions on adjusting the skid shoes. Chute Control Rod (Models 2620, 2840, y 3090XP) To adjust the chute control rod, proceed as follows: 1. Remove the cotter pin from the hole closest to the chute assembly on the chute rotation assembly. 2. Pull out the chute control rod until the hole in it lines up with the second hole in the chute rotation assembly. See Fig. 6-6. Chute Bracket Adjustment (Model 2410) If the spiral at the bottom of the chute directional control is not fully engaging with the chute assembly, the chute bracket can be adjusted. To do so: 1. Loosen the two nuts which secure the chute bracket and reposition it slightly. See Fig. 6-7. Figure 6-6 3. Reinsert the cotter pin through this hole and the chute control rod. See Fig. 6-6. Figure 6-7 2. Retighten the nuts. Off-Season Storage If the snow thrower will not be used for 30 days or longer, follow the storage instructions below. 1. Run the engine until the fuel tank is empty and it stops due to lack of fuel. Do not attempt to pour fuel from the engine. 2. Lubricate the machine as instructed earlier in this section. 3. Store in a clean, dry area. 4. If storing the snow thrower in an unventilated area, rustproof the machine using a light oil or silicone to coat the snow thrower. 5. Clean the exterior of the engine and the snow thrower. NOTE: Refer to the Engine Operator's Manual for information on storing your engine. Section 6 - Maintenance & Adjustments 19