Troy-Bilt TB146 Operation Manual - Page 1
Troy-Bilt TB146 Manual
View all Troy-Bilt TB146 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
TB146 EC 4-Cycle Electric Start Capable Cultivator Operator's Manual English - Page 1 Unpacking the Unit Assembling the Unit Wheel Bracket Wheel Assembly Clevis Pin 1 Remove all contents from the carton. 2 Insert the wheel assembly into the wheel bracket. The "J" shape of the wheel assembly should point away from the unit. 3 Cotter Pin Align the hole in the wheel bracket with the desired hole in the wheel assembly. Insert the clevis pin through the aligned holes. Insert the cotter pin into the clevis pin. 4 Loosen the two handlebar knobs. Swing the handlebars up into the operating position. NOTE: Do not pinch the throttle cable or switch wires. Assembling the Unit Handlebar Knobs Starting the Unit 5 Tighten the two handlebar knobs to secure the handlebars. Readjust the throttle cable and switch wires. NOTE: Do not over tighten the handlebar knobs. Starting the Unit Primer Bulb 6 Set the unit on a flat, level surface. Unscrew the oil fill plug. Pour the entire bottle of oil into the oil fill hole. Reinstall the oil fill plug. NOTE: DO NOT overfill. Never add oil directly into the fuel tank. DO NOT mix oil with gasoline. 7 Place the unit on a level surface. Remove the fuel cap. Fill the fuel tank. Replace the fuel cap. Move the unit at least 30 ft. (9.1 m) from the fuel container and the fueling site before starting the engine. NOTE: Use fresh unleaded gasoline (less than 30 days old). 8 DO NOT Squeeze the throttle control. 10 X 19 Press primer bulb 10 times, or until fuel is visible 10 Stand in starting position. WARNING: Tines WILL ROTATE on START. Always stand in starting position with foot on wheel when starting the unit. 11 DO NOT squeeze the throttle control. Pull starter rope in controlled motion until unit starts. Wait 60 seconds. 12 Then squeeze the throttle control for an additional 30 to 60 seconds to let the engine warm up further. The unit may be used during this period. NO ASSEMBLY TOOLS REQUIRED Electric Starter or Power Start Bit Optional! THESE OPTIONAL ACCESSORIES ARE SOLD SEPARATELY! This unit has an alternate starting method that many find easier to use than pulling a rope. Please contact a local retailer or call 1-800-828-5500 for more information. Information may also be found at www.troybilt.com Throttle Control On/ Off Switch Lower Handle Handle Knobs Upper Handle Choke Lever Starter Rope Tine Shield Fuel Cap Primer Bulb Air Filter Cover Tines DIDN'T START? Repeat the starting instructions. If the unit still fails to start, refer to the operator's manual for additional starting and troubleshooting information. In cold weather (below 40°F), refer to the operator's manual for additional starting instructions. IF THE ENGINE IS HOT Go back to Step 9 Need Help? Call 1-800-828-5500 Español - Page 7 IMPORTANT: READ THE OPERATOR'S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT. NEED HELP? CALL 1-800-828-5500 IN U.S. OR 1-800-668-1238 IN CANADA 769-07453A P00 02/12