URC URC-RF30 Owners Manual - Page 7

BASIC SETUP Pre-Programmed Code Method 11 NOTE: If the Component fails to turn off after you have entered all the code numbers listed for your brand, you can scan through all the other code numbers that are pre-loaded into the RF30 for that Component (in this case TV) by using the UP or DOWN buttons on the screen. (There is a chance that your Component was actually manufactured by another brand.) However, most of the code tables are so large that it is usually faster to use the Learning Method on Page 15. STEP 7: Point the RF30 toward the Component you want to program, (in this example, TV), and punch in the 3-digit code that you wrote down for that specific Component. Use the Number buttons 0-9 on the remote to punch in the code. If the 3-digit code number that you just punched in is correct, the Component will turn off. If the Component does not turn off, continue entering code numbers from your list until the Component turns off. Some brands have several possible code numbers. NUMBER BUTTONS STEP 8: When the Component turns off, press the ON button to turn the Component back on. Now you can test the Volume and Channel buttons (for TV), or PLAY and STOP (for VCR and DVD) to make sure they all work. If any of the buttons do not work properly, you need to UP & DOWN BUTTONS 12 find a new correct code. For example, maybe your Sony TV turned off with code number 147, but the volume controls did not work properly. If this is the case, try the next code number listed for that Component until you find a perfect match. ON BUTTON VOLUME BUTTONS CHANNEL BUTTONS PLAY BUTTON STOP BUTTON BASIC SETUP Pre-Programmed Code Method