Uniden DFR7 User Manual - Page 13

IF... TRY THIS... No display or audio. xx If no display, check the connections. Be sure they are all secure. xx If no audio, check if Voice is turned off. The unit alarms when the vehicle hits bumps. Check the connections. Be sure they are all secure. The unit alarms briefly in the same location but There may be a motion sensor or house alarm in use within no radar source was in view. range. The DFR7 did not alert when a police car was in • The officer may not have radar/laser units turned on. view. • Check that the band is turned on. Press MENU and cycle through the options to get to the bands. If the band is turned off, the OLED will show OFF. Turn the band on. The vehicle starts but the DFR7 does not turn • Verify that the power cord is securely connected to the on. unit and inserted into the cigarette lighter jack. • Change the fuse in the power cord. Unscrew the cigarette lighter plug to access the fuse. SPECIFICATIONS Receiver Type: Antenna Type: Radar Double Conversion Superheterodyne Radar Self-Contained Antenna Linear Polarized E-vector Vertical Laser Pulsed Laser Signal Receiver Laser Front Convex Condenser Lens Frequency: Laser Back Concave Condenser Lens X 10.525 GHz Dimensions 110.00 mm (D) x 69.00 mm (W) x 29.50 mm (H) K 24.150 GHz Weight 6 oz (170g) Ka 33.400 - 36.000 GHz Operating Temp. -4° to +185° F (Radar/Laser) -20° to +85° C (Radar/Laser) Laser 800 nm - 1100 nm Storage Temp. -22° to +203° F (Radar/Laser) -30° to +95° C (Radar/Laser) Detector Type: Operating Power Source DC 11.0 to 16.0 V Radar Scanning Frequency Discriminator USB Interface USB Specification 2.0/1.1 Laser Pulse Width Discriminator Alarm Type Beep (Detected Band and Signal strength) FCC/IC COMPLIANCE FCC: AMWUA1602 ICC: 513C-UA1602 FCC Compliance This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. Avis de conformité à la FCC : Ce dispositif a été testé et s'avère conforme à l'article 15 des règlements de la Commission fédérale des communications (FCC). Ce dispositif est soumis aux conditions suivantes: 1) Ce dispositif ne doit pas causer d'interférences nuisibles et; 2) Il doit pouvoir supporter les parasites qu'il reçoit, incluant les parasites pouvant nuire à son fonctionnement. Tout changement ou modification non approuvé expressément par la partie responsable pourrait annuler le droit à l'utilisateur de faire fonctionner cet équipement. IC Compliance This device complies with Industry Canada license-exempt RSS standard(s).Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause - 13 -