Uniden UDW10003 English Owners Manual - Page 20

If the static is only on 1 camera - Check near the camera for one of the common interference sources. - Try moving the camera away from a suspected source, or try moving the suspected source so it's not between the camera and the receiver. - Try moving closer to the receiver. There is always more noise at the edges of the receiver's range. If the static is on all cameras - Check near the receiver for the source of interference. - Try moving the receiver away from a suspected source, or turn off the source if possible. - Try raising the receiver's antenna so it stands straight up. Resetting Your System Resetting the camera or receiver will erase any changes and set all values back to the default. You should only reset your system under the following conditions: Resetting the camera - You are unable to pair the camera to the receiver. - The image on the screen is frozen. Resetting the receiver - The buttons on the receiver are not responding. - The image on the screen is frozen, and resetting the camera did not help. To reset the camera or receiver: 1. Unplug the AC adapter and make sure the power is off. 2. Extend the antenna and locate the hole for the reset button. 3. Insert a small object (like a pencil point or an unbent paper clip) into the hole and gently press in. 4. Reconnect the AC adapter and let the battery charge fully. 20