Vaddio RoboSHOT 12 USB User Guide - Page 10

RoboSHOT 12 USB Step 4: Place the camera on the mount and connect the desired cables for the application. Check the level again to avoid any of those weird Batman camera angles. Use the provided ¼"-20 x .375 mounting screw to attach the Camera to the mount. The cables are fed through the cable management slots (back or bottom) provided by all Vaddio mounting options. Step 5: After connecting the desired video cables, plug in the camera's 12 VDC, 3.0 Amp power supply AC power cord to an electrical outlet. The camera will boot up and the motors will start up and initialize. The process may look a little spazzy, but it is normal for these direct drive BLDC motors. In a few seconds, the camera will settle down and appear normal. When an image is available, the camera is ready to accept control information from the IR remote control or RS-232, Telnet or internal web server. CONTROLLING THE CAMERA IR Remote Commander The following functions are accessible with the Vaddio IR remote:  Camera Power On/Off (Toggle on/off same button)  Back Light Compensation (Toggle on/off same button)  Data Screen: Toggle on/off the OSD for the RoboSHOT's IP/MAC Address  Camera Select (the remote can operate 3 cameras (with 3-IR Freq.)  Pan/Tilt and Home controls with Reverse and Std. Pan direction  Pan/Tilt Reset  Auto Focus (Toggle on/off same button)  Zoom In/Out controls Wide & Telephoto  Fast speed controls (W & T) Vaddio IR Remote Commander  Slow speed controls (W & T)  Manual Focus On/Off control (Toggle on/off same button)  Near (-) adjustment  Far (+) adjustment  Six (6) pan/tilt/zoom positioning presets (1 through 6)  Preset Set (store)  Preset Reset (clear)  Red LED that indicates IR Transmission and battery level The IR Remote operational characteristics are as follows:  Finding the Camera's IP/MAC Address: Use the data screen button on the remote to turn on and off the IP and MAC address. When turned on the Address will remain on the screen for 30 seconds.  Preset Activation: IR Remote is limited to executing Presets 1 through 6.  Tri-Sync Speed on Preset: If a global Tri-Sync speed is stored in the preset in the internal web pages by the user/admin, then that speed is used. If no Tri-Sync speed is used, then a default medium speed will be used.  Preset Store: IR Remote is limited to positional (PTZ) type presets. To set a preset, position the camera, hold down the Preset Button and touch the one of the preset numbered buttons 1 through 6. RoboSHOT 12 USB - Document Number 342-0981 Rev B Page 10 of 40