Vaddio RoboSHOT 30 RoboSHOT 12 and 30 QUSB System Manual - Page 30

RoboSHOT HD Cameras THE QUICK-CONNECT USB SCREEN SHOT TOUR The internal web pages will allow control of the Quick-Connect USB and control of the attached camera via a network connection. As mentioned previously, the internal web pages for the RoboSHOT and the Quick-Connect USB are very, very similar, but not identical. These web pages will allow the user or administrator to set security passwords, change the IP address, view diagnostics, access the firmware upgrade page and more! Compatible Web Browsers The approved web browsers that work with Quick-Connect USB include; Chrome® (latest version), Firefox® (latest version), Internet Explorer® (versions 8 through 11) and Safari® (versions 6 and 7). These browsers have been tested thoroughly and are compatible. DHCP IP Set-up (Dynamic Host Configuration Protocol) DHCP Set-up (skip this section if Static IP). If the LAN has a DHCP (dynamic host configuration protocol) server, then the IP address, gateway and routing information will automatically be assigned. The QC-USB software is defaulted to DHCP and will attempt to dynamically obtain an IP address using DHCP, but it will fall back to the default address of (169.254.1.1) if no DHCP server can be found. Static IP Set-up: The static IP can be assigned either through the network or directly to a computer using a cross-over cable. Depending on the age of the computer, you may not need a cross-over cable. Either way the steps are the same for network or direct connection to a computer. The default address of the QC-USB camera is 169.254.1.1 and the Subnet mask is 255.255.0.0. Different computer OS types all have their own way of doing things (without question), but they are essentially doing the same stuff, changing the IP address so the web pages of the HD-USB are accessible. QUICK-CONNECT USB WEB PAGES TOUR: Screen Shot: Login The QC-USB webserver is intended as a user's camera control page at one level, and an administrator's management tool at another level, which requires password authentication for access. The Login Page will appear if there is a user name assigned by the administrator. Assigning a user name can limit access to the admin menus by a general user. By default, the User name is blank and the password for the User account is: password. The Administrator can set the name and password for the User account. If no user name is assigned, the web page will automatically open to the Camera Control page. Defaults: User name is blank (assigned by admin). The password is: password. Admin Name is: admin. The password is password. Note: There is only one user name and password. There is only one admin name and password. RoboSHOT HD Cameras - Document Number 342-0796 Rev A Page 30 of 68