ViewSonic PJ750-2 User Guide - Page 11

Using The Projector Use the control buttons on the projector control pad and the remote control to make quick adjustments to the controls listed in the following section. Projector control pad E N G L I S H Remote control LED indicators Standby/On Blank Video Laser RGB Disk pad Standby/On button STANDBY/ON Input button Mute button Reset button Menu button MUTE RESET Auto Menu Menu select Mouse/right Position Reset Magnify Freeze TIMER Volume Mute Timer Figure 6: Projector and Remote Controls Control Buttons Press a control button to display a menu, then use the arrow buttons to adjust the selected control. The buttons on the projector control pad and on the remote control are explained below: Standby/On Button Press the STANDBY/ON button to begin the warm-up period. The power LED flashes green during warm-up and lights a steady green when the projector is ready to use. The projector cannot be restarted within 60 seconds after it is turned off because the projector enters a cool-down mode. This is a safety feature. Input Button (Video and RGB Buttons) Use the INPUT button on the projector or the Video and RGB buttons on the remote control to select the input source. Press the INPUT button on the projector to cycle through input sources: RGB 1, RGB2, Video or S-Video. On the remote control: - Press the RGB button to select a computer as the input source. - Press the Video button to toggle between Video and S-Video. 8 ViewSonic PJ750