ViewSonic PJD5232 PJD5232, PJD5234, PJD7223 User Guide (English) - Page 36

• The default setting is "Auto" when input source is HDMI. • The default setting is "Side-by-Side" when input source is video or computer. "Auto" will be unavailable. • The brightness level of the projected image will decrease. • The Color Mode cannot be adjusted. • 3D Invert • On: Invert left and right frame contents. • Off: Default frame contents. Video/Audio Frequency Adjust the timing of the projector relative to the computer. Note • This functions is only supported under computer mode. Tracking Adjust the phase of the projector relative to the computer. Note • This functions is only supported under computer mode. H Position (Horizontal Position) Adjust the image left or right within the projection area. V Position (Vertical Position) Adjust the image up or down within the projection area. Zoom Using the remote control 1. Press Magnify on the remote control to display the Zoom bar. 2. Press / to magnify the picture to a desired size. 3. Press Enter on the remote control to switch to the paning mode and press the directional arrows to navigate the picture. The zoom bar needed to be shown on screen if we want to switch the paning mode. 4. To reduce size of the picture, press Magnify and press repeatedly until it is restored to the original size. Using the OSD menu 1. Press MENU/EXIT on the projector or Menu on the remote control and then press until the Video/Audio menu is highlighted. 2. Press to highlight Zoom. 3. Repeat steps 2-4 in the section of Using the remote control above. Video Setting Allow you to enter the Video Setting menu. • Sharpness: Sharpen or soften the image. 28