ViewSonic PJL1035 Service Manual - Page 10
PJL1035-2, Message, table
UPC - 766907222111
View all ViewSonic PJL1035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
PJL1035-2 Message table al On-screen display The following messages are displayed on the screen. MESSAGE Action CHANGE THE LAMP AFTER REPLACING LAMP, RESET THE LAMP TIMER. CHANGE THE LAMP AFTER REPLACING LAMP, RESET THE LAMP TIMER. THE POWER WILL TURN OFF AFTER * Hr. Blinking of CHANGE THE LAMP The lamp has been in service for long. Replacement with a new lamp is recommended. The lamp will go off automatically when the lamp replacement time is exceeded. *1 The total lamp service time will exceed the lamp replacement time in • hours. The lamp will go off automatically when the lamp replacement time is exceeded. Replace with a new lamp before that. *1 The asterisk C.) indicates the number of hours remaining before the lamp goes off automatically. The total lamp service time has exceeded the lamp replacement time. The lamp will go off automatically about 10 minutes after it starts blinking. Replace with a new lamp.•2 NO INPUT IS DETECTED Signal is hot input. SYNC IS OUT OF RANGE The horizontal frequency of the input signal exceeds the range of the projector, it cannot be displayed. *1 This message are not displayed after 3 minutes. But this message are displayed when you turn on the power again. *2 It is possible to again turn on the power, however the power will go off after about 10 minutes. Indicator display The ON indicator, LAMP indicator and TEMP indicator will light or blink in the following cases. ON indicator LAMP indicator TEMP indicator Meaning Remedy Lights orange Goes off Goes off Standby mode Blinks green Goes off Goes off During warming up Lights green Goes off Goes off During operation *1 Blinks orange Goes off Goes off During cooling down Lights red Lights red Lights red Blinks red Lights red Blinks red Goes off Blinks red Goes off Goes off Blinks red Goes off Lamp cannot light '2 Cool projector by power off for 45 minutes. If the indicator is still it, lamp may be defective. Replace. Lamp is not inserted or the Securely insert the lamp or close the lamp door open lamp door. Cooling fan accidented Replace fan. The total lamp service time has exceeded the lamp replacement time. Replace lamp and reset the accumulated lamp operation time. ViewSonic Corporation Confidential - Do Not Copy -7-