ViewSonic PJL1035 Service Manual - Page 26
PJL1035-2, replace, Option, VOLTAGE, TEMPERATURE, PRESSURE
UPC - 766907222111
View all ViewSonic PJL1035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
PJL1035-2 6 - 3 About Lamp Replacement Light source lamp has a service life. The picture will become dark or color will be poor when the lamp is used for a long time. If usage of lamp is continued in such cases, it could cause a malfunction. Replace lamp with new one. As reference for replacement time, indicator will operate or message will be displayed when the power is turned on, as shown on page 31,32. In these cases the lamp should be replaced. (Caution) Also LAMP indicator will light when the lamp becomes too hot. Turn off the power and let the projector cool for 45 minutes. Turn on. 1. How to replace lamp (Option lamp : Lamp unit DT00205) A AA HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE When replacing lamp, turn off and remove AC cord, wait 45 minutes to let lamp cool. Highpressure lamp when hot, may explode if improperly handled. (Caution) • For disposal of used lamp, treat according to the instruction of community authorities. • Since the lamp is made of glass, do not apply shock to it and do not scratch it. • Also, do not use old lamp. This could also cause explosion of the lamp. • If it is probable that the lamp has exploded (explosive sound is heard), disconnect the power plug from the Reflector power outlet and replace lamp. The lamp is covered Front glass by front glass and air-tight structure, but, in rare cases, the reflector and the inside of the projector may be damaged by scattered broken pieces of Lamp glass, and broken pieces could cause injury when being handled. 1. Turn the main power switch off and disconnect the power plug from the power outlet. 2. Remove the lamp cover. • If lamp is hot at this time, this could cause burn. Wait for minimum 45 minutes until lamp is cooled down. • Loosen a screw and remove the cover. Lamp cover 3. Loosen two screws and pull the handle to remove the lamp. • If the screws are not loosened completely, your fingers may be damaged. • Do not insert your hand into the box after the lamp is removed. (There are optical parts inside. If touched by hand, it may result in color unevenness, etc.) Screw Screw Lamp ViewSonic Corporation - 23 - ' : Confidential - Do Not Copy