Viking 18" Fully Integrated All Freezer with Custom Panel Installation Instruc - Page 18

Leveling Unit, Kickplate Installation

Page 18 highlights

Leveling Unit Once the unit is in position, height adjustment can be made from the front. Remove acess panel just below the water filter. Using a 5/16" hex drive, turn clockwise to raise the unit or counterclockwise to lower. Use the lowest torque setting when using a power drill. Do not turn the leveling legs by hand. When the unit is properly leveled, door/drawer adjustments are less likely to be necessary. IMPORTANT NOTE: Level the unit to the floor, not surrounding cabinetry. This could affect the operation of the unit, such as door closing. Front Panel B Left Front Adjustment A Left Rear Adjustment Right Rear Adjustment Right Front Adjustment Kickplate Installation After the unit has been adjusted to the proper height, place the kickplate on the lower front with the adjustment screws in the slots. Let the kickplate drop until it hits the floor. Tighten the screws. Front of unit Adjustment slot Adjustment screws kickplate 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

18
Leveling Unit
Once the unit is in position, height adjustment can be made from
the front. Remove acess panel just below the water filter.
Using a
5/16" hex drive, turn clockwise to raise the unit or counterclockwise
to lower. Use the lowest torque setting when using a power drill.
Do not turn the leveling legs by hand. When the unit is properly
leveled, door/drawer adjustments are less likely to be necessary.
IMPORTANT NOTE:
Level the unit to the floor, not surrounding
cabinetry. This could affect the operation of the unit, such as door
closing.
A
B
Front Panel
Left Front
Adjustment
Right Front
Adjustment
Left Rear
Adjustment
Right Rear
Adjustment
Kickplate Installation
After the unit has been adjusted to the proper height, place the kickplate on the lower front with the adjustment screws in the slots.
Let the
kickplate drop until it hits the floor.
Tighten the screws.
kickplate
Front of unit
Adjustment screws
Adjustment slot