Viking FDB451 Installation Instructions - Page 10

Installation 1 2 2 2 1 4 x4 3 Carefully lay dishwasher on its back and attach the kick plate brackets. Screws for the brackets will already be in the base. Note: Be careful not to pinch hoses or power cord beneath dishwasher. 3 1 2 To adjust the depth of the kick plate, loosen screws on the bracket and position in the required depth. Tighten screws and repeat for other side. 4a 1 1 Using tie strap attached to dishwasher, band water line, drain line, and power cord together. 4b 1 1 2 x2 For installation with trim, attach brackets with two screws (1 per bracket). 5 2 x2 For installation without trim (301 models only), attach brackets with two screws (1 per bracket). 18 Position unit in front of cutout. Installation (cont.) 6 1 2 Slide unit into opening; be sure to feed water, electrical and discharge lines into adjacent cabinet. Leveling 7 Equal distance 8 DOWN UP DOWN UP DOWN UP Place a level on handle, then adjust to appropriate height. Left and right adjust side to side and center adjusts front to back. To check level, front to back, pull the top rack half-way out of unit. The rack should remain stationary and not move in or out. Note: Leveling is important for optimal performance. 19