Viking FDB451 Installation Instructions - Page 11
Final Installation
View all Viking FDB451 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Final Installation 9a 9b 1 x4 2 x2 3 For installation with trim, secure dishwasher by attaching provided mounting plugs and wood screws through trim panels into cabinets. Attach screws through top brackets into cabinets. 10 Minimum 20" (50.8 cm) from floor Install High Loop Clip, which is provided, a minimum of 20" (50.8 cm) from the floor. Refer to the Drain section of "General Information" for proper installation requirements. 12a x2 For installation without trim, secure dishwasher by attaching screws through top brackets into cabinets. 11 1.0" (2.5 cm) Cut here for 5/8" (1.6 cm) Cut here for 3/4" (1.9 cm) Identify discharge connection size; cut line to correct size and connect. Clamp if necessary. 12b (Discharge with food waste disposer) Note: Be sure to remove the knockout or plug from the fitting of the disposer before connecting drain line. 20 (Standard discharge) Final Installation (cont.) 12c Air Gap 12d Air Gap (Discharge with air gap) 13 (Discharge with food waste disposer and air gap) 14 Connect water line. Plug LED light into dishwasher (select models only) and install kick plate. Note: DO NOT block the dry air exhausts (rectangular slots on the access panel) with kick plate or base board. Blocking the opening could reduce the dry performance and cause unwanted condensation. 21