Viking FDB451 Installation Instructions - Page 9

Trim Installation Options (451 Models) 1a Dishwasher ships with trim installed for flush install. If needed, attach wiper gasket to dishwasher by pulling protective film off adhesive back. Apply behind hemmed edge of side trim. 1b 2b 2 2 x6 1 To install dishwasher without trim, remove the 6 screws (3 per side) and remove trim. If needed, attach wiper gasket to dishwasher by pulling protective film off adhesive back. Apply to leading edge of dishwasher frame. Trim gasket to fit. 16 Counter Balance Spring Adjustment (if necessary) 1 2 1 1 2 2 Disconnect cable from hook. Increase tension 3 Decrease tension Set counter balance spring connector in appropriate location. Remove spring from dishwasher. 4 1 2 Reconnect cable to hook. Note: For custom panel installation, the door may require adjustment to the preload of the counterbalance springs. Follow these steps to adjust the tension. 17