Viking FDB451 Installation Instructions - Page 5
Custom Door Panel
View all Viking FDB451 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Custom Door Panel (Specifications for FDB451 Models) 14" (35.6 cm) 10-5/8" (27.0 cm) Locator ø1/8" 4 places (0.3 cm) 22-5/32" (56.3 cm) 29-3/4" (75.6 cm) to 31-1/4" (79.4 cm) 13-1/2" (34.3 cm) 22-21/32" (57.5 cm) 23-9/32"with trim (59.1 cm) or 23-7/8" without trim (60.6 cm) Note: Back side of panel shown. Use caution not to drill through front of panel. Note: If panels are made longer than 29-3/4" (75.6 cm), the door panel will be taller than dishwasher control panel. Note: All hole location dimmensions should be measured from the bottom of the door per the illustration above. 8 Custom Door Panel (Installation Option) Have the overlay panel constructed per dimensions. The panel thickness MAY NOT exceed 3/4" (1.91 cm) for flush installation in most cabinets. Ensure that the design, construction, and installation of the panel overlay and its handle mounting is sufficient to reliably operate in this application with a maximum panel weight of 18 lbs. (8.2 kg.) Custom panels should not exceed 18 lbs. (8.2 kg.) 1 Locators 2 2 2 1 x2 4 x2 3 Pre-drill two holes with 1/8" drill bit for the locators using dimensions shown in the figure. Attach plastic locators using the Torx (T20 BIT) pan head screws provided in the hardware package. 3 x4 Pre-drill other four locations for wood screws to attach the panel to the dishwasher door using the dimensions shown in the figure. 4 1 1 Use locators to align the panel to the dishwasher door holes. 1 1 1 x4 1 2 Use non-marring clamps to hold custom panel in place. Use the truss head 1-3/4" long screws provided in the hardware package for the panel attachment. Note: If you are using any special panel material and that require special screws, always use a #8 1-3/4" long truss head Torx stainless steel screws. The screws MUST BE stainless steel to avoid corrosion. 9