Viking FDSB5483 Installation Instructions - Page 23
Moving Unit
![]() |
View all Viking FDSB5483 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
HGeandelrianleInformation Area Requirements • Most of the unit's weight is at the top. Extra care is needed when moving the unit to prevent tipping. • DO NOT remove protective film until unit is in operating position. • All four leveling legs must contact the floor to support and stabilize the full weight. • DO NOT drop unit. • Remove exterior shipping materials prior to moving unit into home, except door latching device. • Use two or more people to move and install unit. Failure to follow this instruction can result in back or other injury. • To avoid personal injury, wear gloves when performing any installation procedure and wear eye protection when cutting metal straps. Tip Over Hazard Appliance is top heavy and tips easily when not completely installed. Keep doors closed until appliance is completely installed and secured per installation instructions. Use two or more people to move and install appliance. Failure to do so can result in death or serious injury. Unpacking Unit 1. Remove top and bottom strap. 2. Remove top cap. 3. Cut carton rear approximately 1/4" (0.6 cm) to 1" (2.5 cm) from right corner with a utility knife extended 1/4" (0.6 cm). 4. Remove carton and exterior packaging. Save cardboard shipping material to protect floor surface when installing unit. Remove anti-tip board and kickplate from rear of unit. Moving Unit Remove shipping brackets from skid by removing four bolts (two on each side) with a 1/2" (1.3 cm) deep-well socket wench and a pair of pliers. Note: Tilting unit is not required to remove shipping brackets. Slip appliance dolly between unit and skid. Remove unit from skid. Note: Use excess packaging to protect decorative trim; also, verify that leveling legs are up (0" adjustment). 23
![](/manual_guide/products/viking-vcsb5483-installation-instructions-3e3f8af/23.png)