Viking FDSB5483 Installation Instructions - Page 24
Installation, Flush Mount Side Trim Installation
View all Viking FDSB5483 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
HFleuashdlMineount Side Trim Installation (Sold Separately) Note: If the unit is to be installed flush with the cabinets, the flush mount side trim must be installed first. If not, skip to "Installation". Step 1 - Locate the necessary parts: Two (2) flush mount trim pieces and a hardware kit with twenty-two (22) screws. Step 3 - Align the top of the flush mount side trim with the top of the unit's machine compartment. Using the screws included in the hardware kit, attach the side trim to the unit, only using the holes visible through the side trim. Note: DO NOT use the screw holes in the machine compartment. Step 2 - Remove the side trim on the refrigerator and discard the trim and screws. Installation 1 2 Place unit in front of cutout. 3 Pull the center grille louver up at an angle and pull out. 4 Using an 8" (20.3 cm) magnetic nut driver, remove the two 1/4" (0.6 cm) screws. 24 Remove grille assembly.