Viking MVBI7360W Installation Instructions - Page 3

IMPORTANT - Please Read and Follow! • Make sure that incoming voltage is the same as unit rating. An electric rating plate specifying voltage, frequency, wattage, amperage, and phase is attached to the product. • To reduce the risk of fire, electrical shock, or injury to persons, installation work and electrical wiring must be done by a qualified technician in accordance with all applicable codes and standards, including fire-rated construction. • The installer should leave these instructions with the consumer who should retain them for local inspector's use and for future reference. For additional information or installation videos, visit our website at www. vikingrange.com Your safety and the safety of others is very important. We have provided many important safety messages in this manual and on your appliance. ALWAYS read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to hazards that can kill or hurt you and others. All safety messages will be preceded by the safety alert symbol and the word "DANGER" or "WARNING." These words mean: DANGER You will be killed or seriously injured if you don't follow instructions. WARNING You can be killed or seriously injured if you don't follow instructions. All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. It is your responsibility to: • comply with installation specifications and dimensions. • properly install unit. • remove any moldings or decorative panels that prevent the unit from being serviced. • make sure that you have these materials (not provided with your unit), which are necessary for proper installation: • 1/4" (6 mm) copper tubing with shutoff valve • 1- Saddle valve (do not use self-piercing feature of the valve) • assure that floor will support unit, door panels and contents (approximately 1200 pounds [540 kg]). • provide a properly grounded electrical outlet. • assure that location will permit appliance doors to open 90º minimum. Required tools • Drill • Drill bits - 3" Phillips (Ph2), Torx (T15 & T20), 1/4" and 5/16" hex drive • Rubber mallet • 3/8" wrench 3