Viking PDDP242SS Use and Care Manual - Page 15
Filling Rinse Agent Dispenser
View all Viking PDDP242SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Operation Operating the Dishwasher A • Open the detergent container by pushing the lock to the right A. • Pour/put the detergent into the dispenser. • Close the lid until it clicks in. • The detergent container holds a total of 40 ml/8 tsp. of detergent • Marking lines on the inside of the detergent container aid in providing the correct amount of detergent. When the dishwasher is fully loaded and the dishes are very dirty, we recommend filling the detergent container up to the 25 ml/5 tsp. mark. When the dishes are less dirty, it is generally sufficient to fill the detergent up to the 15 ml/3 tsp. mark. • The detergent amounts for the individual cleaning programs are shown in the Program Table on page 21. • Fill amounts given are for standard powder detergent. Amounts may vary if you use liquid or concentrated power detergent. Tablet detergents should be placed in detergent container 1 with the cover closed. • Follow instructions on the package of the detergent when using liquid dishwasher detergent, concentrated powder detergent, or tablet detergent. • Deviations are possible depending on how dirty the dishes are and how hard the water is in your location. • If your dishes have been in the dishwasher for some time without being washed, also fill the smaller container 2 up to the top. 28 Operating the Dishwasher Filling Rinse Agent Dispenser WARNING Keep your rinse agents out of the reach of children. Ingestion or inhalation of rinse agent may cause serious injury. Avoid contact with skin and eyes, and keep children and people in poor health away from rinse agents. NOTICE • Only use rinse agents suitable for use in dishwashers. Rinse aids allow washing water to rinse off more cleanly and prevent watermarks or streaks on the dishes. • If you use "2 in 1" or "3 in 1" detergents/tabs, you do not need additional rinse agent. • Open the rinse agent dispenser by pressing the lock B. • Carefully pour in rinse agent to the MAX mark. • Close the lid until it clicks in 3. • Carefully wipe off spilled rinse agent. Excessive rinse agent causes excessive foam formation, which may hinder cleaning. Set the Dose of Rinse Agent The dose of rinse agent to be used can be set by means of the dispenser regulator 4 between levels 1 and 6. Change the setting, only if the following applies after washing: • Watermarks are visible on the dishes: Set dosage higher. • Streaks are visible on the dishes: Set dosage lower. 29 Operation