Viking RDMOR200SS Installation Instructions - Page 4
Viking RDMOR200SS Manual
View all Viking RDMOR200SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
7 Preparation of the Oven Separate mounting plate from oven by removing two screws. See illustration below. Save these screws for use in section Mounting Oven to Wall, figure /. (B) Horizontal Exhaust: Outside Ventilation figure Mounting Plate Back of Microwave 1) HORIZONTAL EXHAUST: Remove 2 screws from back edge and 3 screws from the top center of Fan Cover Bracket. Save 2 screws to be used later and discard remaining 3. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket. Hood Fan Unit Oven for Installation) This Built-in Microwave Hood is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. Recirculating - non-vented, ductless. Follow installation procedure (A). Recirculating requires the use of the Charcoal Filter, which has already been installed in the oven. Horizontal Exhaust - outside ventilation. Follow installation procedure (B). Vertical Exhaust - outside ventilation. Follow installation procedure (C). 2) HORIZONTAL EXHAUST: Lift Hood Fan Unit carefully and slip wires out of cavity. • Caution: Do not pull or stretch hood fan wiring. figure 8 Ventilation System (Preparing figure 4 5 6 7 figure (B) (A) Rotate 180˚ (A) Recirculating: Non-Vented, Ductless Operation • The unit is shipped assembled for recirculating. • The Exhaust Damper Assembly 7 is not required for recirculating operation. 3) HORIZONTAL EXHAUST: Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. See Figure 7 (A). Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan Unit. See Figure 7 (B). E4