Viking RDMOR200SS Installation Instructions - Page 7
Viking RDMOR200SS Manual
![]() |
View all Viking RDMOR200SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
9 Oven Installation 10 Mounting Oven to the Wall ( figure Utilization of the carton may make installation easier. Space more than wall thickness ~ figure Top Side Wall Cutting Line 2) MOUNTING PLATE: Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts through the holes in the wall with the Toggle Nuts closed. Use Wood Screws 1 to attach the Mounting Plate to studs. 1) MOUNTING OVEN TO THE WALL: Place carton upside down. NOTE: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting Plate and the end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the Toggle Nut will not be able to open on the other side of the wall. Also, once a Toggle Nut opens, it cannot be withdrawn from the hole; therefore make sure all of the Toggles are in the correct position before insertion. + figure (A) ) figure (B) 2) MOUNTING OVEN TO THE WALL: Using cutting line around the carton, cut into two pieces (A) and (B). , figure 3) MOUNTING PLATE: Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you and turn clockwise to tighten. 3) MOUNTING OVEN TO THE WALL: Position oven to assist in mounting to the wall. E7
![](/manual_guide/products/viking-rdmor200ss-installation-instructions-6fb3880/7.png)