Viking TVDR361 Installation Instructions - Page 12
Electrical Requirements
View all Viking TVDR361 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Electrical Requirements WARNING ELECTRICAL SHOCK HAZARD To avoid the risk of electrical shock, personal injury or death; verify electrical power is turned off at the breaker box and gas supply is turned off until the range is installed and ready to operate, installation by an authorized installer only. Electrical Requirements This product is manufactured with the neutral terminal connected to the cabinet. Use a 3-wire, agency approved, power supply kit with closed loop terminals rated per the National Electrical Code, ANSI/NFPA 70-latest edition (See Rating chart below). If local codes prohibit grounding through the neutral, use a 4-wire, agency approved, power supply kit with closed loop terminals rated per the National Electrical Code, ANSI/NFPA 70-latest edition (See Rating chart below). RATING* Specified Rating of Power Supply Cord Kit and Circuit Protection 120/240 Volts 120/208 Volts Amps 4.5 - 10.2 KW 4.5 - 10.2 KW 50 *The National Electric Code calculation for Electrical Load is less than the Total Connected Electrical Load listed on the model/ serial rating plate. A GFI shall be used if required by NFPA-70 (National Electric Code), federal/state/local laws, or local ordinances. •The required use of a GFI is normally related to the location of a receptacle with respect to any significant sources of water or moisture. •Manufacturer will NOT warranty any problems resulting from GFI outlets which are not installed properly or do not meet the requirements below. If the use of a GFI is required, it should be: •Of the receptacle type (breaker type or portable type NOT recommended) •Used with permanent wiring only (temporary or portable wiring NOT recommended) •On a dedicated circuit (no other receptacles, switches or loads in the circuit) •Connected to a standard breaker of appropriate size (GFI breaker of the same size NOT recommended) •Rated for Class A (5 mA +/- 1 mA trip current) as per UL 943 standard •In good condition and free from any loose-fitting gaskets •Protected from moisture (water, steam, high humidity) as much as reasonably possible 12