Viking VCSO210SS Installation Instructions - Page 7

Installation 8 FLANGE 28" (712 mm) CL FIGURE 8-A 8.2 Place the oven on a table or stand positioned in front of the cabinet where the oven is to be installed. One person should hold the oven while the other connects it to the electrical outlet. 8.3 Install the oven into the shelf with adjusting mark on EXHAUST DUCT BOTTOM to the center line marked on front edge as shown in Figures 8 and 8-A. Then push the oven until the flange of EXHAUST DUCT BOTTOM touches the edge of the wall or cabinet opening. Avoid pinching the cord between the oven and any wall as shown in Figure 8. 9 SCREW (B) SCREW (B) SCREW (B) SCREW (B) STEP 9: FRAME INSTALLATION Position the BACK FRAME to align with the predrilled holes that were drilled with the mounting template. Check that it is level and then secure with four SCREWS (B). See Figure 9. ! SNAP AT TACHMENT SCREW (B) FIGURE 8-B SCREW (B) STEP 8: OVEN INSTALLATION MOUNTING TEMPLATE: Align the mounting template center line with the center of the cutout and the floor line with the floor of the cutout. Tape it into place. Predrill 4 holes marked "A" with a 1/16" drill bit. Remove template from the cabinet. CAUTION: Never hold the handle when moving the oven. Two persons are required to install the oven. 8.1 Establish center line of opening and mark front edge. STEP 10: DECORATION INSTALLATION Place the FRONT decoration onto the FRAME and align ball studs and receivers. Secure the Decoration to the FRAME by firmly pushing the front frame onto the back frame engaging the four (4) snap attachments. See Figure 10. E7