Viper 5204 Owner Manual - Page 13
Basic Commands Direct Access - replacement remote
View all Viper 5204 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Basic Commands (Direct Access) No Ghost LED's on Arm Press and release The alarm arms, doors lock (if connected), and the siren chirps and parking lights flash once. The Arm LED and beeps play to confirm. If Valet mode* is On, the doors lock and the Arm LED, LED and a fault tone plays. Exit Valet mode to arm the alarm normally. If a trigger zone fault is detected the siren chirps once again and the remote will emit a Trigger Zone Fault Report**, the Arm LED, LED and a fault tone plays. To Arm and Panic Press and hold The alarm Arms (or Locks in Valet) and, after 2 seconds, sounds the siren and flashes the parking lights. The ghost LED's flash and siren tones play to confirm. Press the or button to stop the output. Disarm Press and release The alarm disarms, doors unlock (if connected), and the siren chirps and parking lights flash twice. The Disarm LED and beeps play to confirm. If Valet mode* is On, the doors unlock and the Disarm LED, LED and fault tones play. An Alarm Report** will replace the disarm output if the alarm was 10 © 2011 Directed Electronics. All rights reserved.