Vtech CS6529-3 User Manual - Page 76

Appendix California Energy Commission battery charging testing instructions This telephone is set up to comply with the energy-conserving standards right out of the box. These instructions are intended for California Energy Commission (CEC) compliance testing only. When the CEC battery charging testing mode is activated, all telephone functions, except battery charging, will be disabled. To activate the CEC battery charging testing mode: 1. Unplug the telephone base power adapter from the power outlet. Make sure all handsets are plugged with charged batteries. 2. While you press and hold /FIND HANDSET, plug the telephone base power adapter back to the power outlet. 3. After about 20 seconds, when the IN USE light starts flashing, release /FIND HANDSET and then press it again within 2 seconds. When the phone successfully enters the CEC battery charging testing mode, the IN USE light turns off and all handsets display 1.PRESS FIND HS ON BASE 4 SEC and 2.THEN PRESS # ON HANDSET alternately. When the phone fails to enter this mode, repeat Step 1 through Step 3 above. The telephone base will be powered up as normal if you fail to press /FIND HANDSET within 2 seconds in Step 3. To deactivate the CEC battery charging testing mode: 1. Unplug the telephone base adapter from the power outlet, then plug it back in. Then the telephone base is powered up as normal. 2. Place your handset in the telephone base to register it back to the system. After about 10 seconds, the handset displays Registering... When the registration process completes, the handset displays Registered and you hear a confirmation tone. The registration process takes about 90 seconds to complete. If the registration fails, the handset displays Failed and then To register HS and See manual alternately, remove the handset from the telephone base. Repeat Steps 1 and 2 again. Only one handset can register to the telephone base at a time. 72