Vtech DigiArt Creative Easel User Manual - Page 10

Getting Started

Get Vtech DigiArt Creative Easel PDF manuals and user guides View all Vtech DigiArt Creative Easel manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

GETTING STARTED Step 2: Unsnap A2, lift the CHALKBOARD/DRY-ERASE BOARD (A) with one hand and move the back legs forward with the other hand. Insert A2 into the slot on the back of the SUPPLIES TRAY (B), lining up the hole of A2 with the center screw of the SUPPLIES TRAY (B). Step 3: Tighten the center screw by pushing it in and turning it clockwise to fix it in position. GETTING STARTED BATTERY INSTALLATION 1. Make sure the unit is turned OFF. 2. Locate the battery compartment on the bottom of the chalkboard. Open the battery cover by sliding the tab. 3. Remove the exhausted batteries and install 4 new "AA" batteries as illustrated. 4. Replace the battery cover and push down until it clicks into position. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
10
GETTING STARTED
Step 2:
Unsnap A2, lift the
CHALKBOARD/DRY-ERASE BOARD (A)
with one
hand and move the back legs forward with the other hand. Insert
A2
into
the slot on the back of the
SUPPLIES TRAY (B)
, lining up the hole of
A2
with the center screw of the
SUPPLIES TRAY (B)
.
Step 3:
Tighten the center screw by pushing it in and turning it clockwise to fix
it in position.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned
OFF
.
2. Locate the battery compartment on the
bottom of the chalkboard. Open the battery
cover by sliding the tab.
3. Remove the exhausted batteries and install
4 new “AA” batteries as illustrated.
4. Replace the battery cover and push down
until it clicks into position.