Vtech Kidizoom Action Cam Purple User Manual - Page 35

KIDIZOOM® ACTION CAM ACCESSORIES 3. Remove the protective cover of the adhesive surface and stick it on a clean, flat and smooth surface. Note: If the surface is not very flat or a bit curved, such as that of a helmet, add the extra two double-sided adhesive tape strips (included) onto the adhesive flat mount to improve the contact area between the surface and the adhesive flat mount. Remove the protective covers of the adhesive flat mount and the extra double-sided adhesive tape strips, stick the two tape strips onto both tips of the adhesive surface of the adhesive flat mount before sticking the adhesive flat mount to the surface you would like to stick it on. 4. Apply firm pressure to the adhesive flat mount and the contact surface, making sure that the surface makes contact over the entire area. Note: Maintain this pressure for several minutes to increase the adhesive bond strength. 5. It is recommended that the adhesive flat mount stay on the surface at room temperature for 1 day before using to allow the ultimate strength to be achieved. At room temperature, approximately 50% of the ultimate strength will be achieved after 20 minutes, 90% after 24 hours and 100% after 72 hours. 6. Mount the holder / waterproof case onto the adhesive mount. Align the tripod screw hole on the camera holder / waterproof case to the screw of the adhesive mount. Screw the knob on the adhesive mount clockwise to affix the camera on the mount. 7. Loosen the angle adjustment handle and you can rotate the angle adjustment arm to adjust the capture angle. 8. Tighten the angle adjustment handle after you set the capture angle. 35