Vtech vt40-2420 User Manual - Page 9
Basic Operations, Getting Started
View all Vtech vt40-2420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Getting Started Basic Operations Setup Do Not Disturb (DND) If you do no want a particular handset to receive calls, activate the DND function by doing the following: • Press FUNCTION key followed by the 4(DND) key. • The handset will display DO NOT DISTURB! • To cancel the DND press FUNCTION followed by the 4(DND) key again. Note: When DND is enabled, you will not be able to pre-dial numbers. Wall Mounting The Wall Mount bracket is designed for use on standard Wall Mount plates only. • Remove the wall mount cover at the back of the Base Unit • Line up the tabs on the wall mount bracket with the holes at the back of the Base Unit. Snap the wall mount bracket firmly in place. • Mount the Base Unit on the wall. Position the Base Unit so the mounting stubs will fit into the holes on the wall mount bracket. Slide Base Unit down on the mounting stubs until it locks into placs. Placing Calls Live Dialing • Press the desired LINE key or SPK.PHONE (for handsfree on next available line). Listen for dial tone. • Enter the number you wish to dial • To end a call press OFF or place handset in charger cradle Pre-Dialing • Enter the number you wish to dial on the display. • Press the desired LINE key or SPK.PHONE (for handsfree on next available line). • To end a call press OFF or place handset in charger cradle Remove Wall Mount Cover Wall Mount Bracket 16 17