Waring MXE2000 Instruction Manual - Page 8

ELLIPSE JAR 1. Wash, rinse, sanitize, and dry container prior to initial use and whenever it will not be used again within a period of 1 hour. 2. Wash and rinse container after each use. 3. Clean and sanitize motor base prior to initial use and after each use. 4. Washing solutions based on non-sudsing detergents and chlorine-based sanitizing solutions having a minimum chlorine concentration of 100 PPM are recommended. The following washing, rinsing, and sanitizing solutions, or their equivalents, may be used. SOLUTION PRODUCT Washing International Products Corporation LF2100 Liquid Low-Foam Cleaner Rinsing Plain Water DILUTION IN WATER 1%-2%: 1¼ - 2¾ ounce/gallon (lower dilution of 1% for normal cleaning and up to 2% for more stubborn soils) TEMPERATURE Room temperature Warm 95˚F (35˚C) Sanitizing Clorox® Regular Bleach (8.25% hypochlorite concentration) 2 teaspoons/gallon (alternately a bleach with 5.25% hypochlorite concentration can be used at dilution of 3 teaspoons/ gallon) • In repetitive batch-processing applications, frequent cleaning of the container will prolong the life of the blade assembly. In no case should actual running time between cleanings exceed ½ hour. • Do not use container to store processed foods or beverages. TO WASH AND RINSE CONTAINER: 1. REMOVE CONTAINER FROM MOTOR BASE. Remove Ellipse dasher system (lid and dasher). Rinse container interior and lid under running water. Add washing solution to container. Scrub and flush out the container interior to dislodge and remove as much food residue as possible. Empty container. 2. Wipe down exterior of container with a soft cloth or sponge dampened with washing solution. Fill container ¼ full with fresh washing solution, cover (with lid only), place on motor base and run on the highest speed for two (2) minutes. Empty container. 3. Repeat step (2) using clean rinse water in place of washing solution. IMPORTANT NOTE: IN ORDER TO MINIMIZE POSSIBILITY OF SCALDING, TEMPERATURE OF WASHING SOLUTION AND RINSE WATER MUST NOT EXCEED 115˚F (46˚C), AND QUANTITY USED MUST NOT EXCEED ¼ CONTAINER FULL. TO SANITIZE AND DRY CONTAINER: 1. Wipe down exterior of container with a soft cloth or sponge dampened with sanitizing solution. 2. Fill container with sanitizing solution, cover, place on motor base, and run on high speed for two (2) minutes. Empty container. Dislodge any residual moisture from blade assembly by placing empty container on motor base and running on the highest speed for two (2) seconds. 3. Sanitize lid and lid insert by immersing in sanitizing solution for two (2) minutes. 4. Do not rinse container, lid, or lid insert after sanitizing is completed. Allow parts to air-dry. TO CLEAN AND SANITIZE MOTOR BASE: 1. UNPLUG POWER CORD. Wipe down exterior surfaces of motor base with soft cloths or sponges dampened with washing solution, rinse water, and sanitizing solution. Prevent liquid from running into motor base by wringing all excess moisture from cloths or sponges before using them. DO NOT IMMERSE MOTOR BASE IN WASHING SOLUTION, RINSE WATER, OR SANITIZING SOLUTION. 2. Allow motor base to air-dry before using. Any other servicing should be performed by an authorized service representative. 14 15