Waring WDM360T Instruction Manual - Page 6

The drink mixer can be operated without engaging the ON/OFF cup actuator by using the PULSE toggle switch. The PULSE switch will operate at whatever speed the 3-speed switch is set. The PULSE switch will operate only while pressed forward or backwards. Keep a firm grip on the mixing cup while using PULSE CLEANING & MAINTENANCE INSTRUCTIONS 1. Rinse cup thoroughly under running water. Add 8 ounces of clean water to the cup. Place cup in the normal operating position on the mixer and run on HI (III) speed for two (2) minutes. Empty cup. 2. UNPLUG MIXER POWER CORD FROM ELECTRICAL OUTLET. 3. To remove the bottom cup supports (C), simply push each support up then pull out towards you. 4. To remove the upper cup supports (D), firmly hold the notches on both sides of the support, then pull directly out from the base. 5. Wash, rinse and sanitize the upper and bottom supports and cup. Sanitize these parts by immersing in sanitizing solution for two (2) minutes. Shake excess moisture off and allow all parts to air-dry. 6. Working from the top down, wash, rinse, and sanitize the portion of the mixer housing situated directly over the mixing cup and the portion of the spindle above the agitator using absorbent wiping cloths moistened with cleaning solution, rinse water and sanitizing solution. 7. Reassemble ON/OFF switch actuator and mixing cup supports to mixer housing by reversing steps 3 and 4. 8. For each spindle, wash, rinse and sanitize the bottom of the 6