Waring WFP16SC Instruction Manual - Page 12
Disassembly Of Continuous-feed, Chute Parts
View all Waring WFP16SC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
assembly of continuous-feed chute). Position the dicing grid so that it fits securely on the tabs of the continuous feed chute. Guide the stem of the slicing blade through the center hole of the dicing grid and over the drive shaft. Be sure that the slicing blade is completely secured on the shaft by spinning the disc lightly until it is almost flush with the dicing grid. Do not turn on the unit until the continuous-feed chute is properly assembled with the cover. To remove dicing assembly, first unplug the food processor, rotate dicing blade counterclockwise and lift up from the edges. Be careful not to touch the blade when removing dicing assembly as it is very sharp. Next lift the dicing grid. NOTE: Dicing assembly (WFP16S26) is to be handwashed only. DO NOT PUT DICING BLADE OR GRID IN DISHWASHER. NEVER ATTEMPT TO START THE FOOD PROCESSOR WITHOUT THE CHUTE AND COVER LOCKED INTO POSITION. • Insert the small food pusher into the large food pusher opening. Now you are ready to insert the large pusher into the feed tube opening. • Once feed chute is assembled, place separate container under the feed chute. DISASSEMBLY OF CONTINUOUS-FEED CHUTE PARTS ALWAYS UNPLUG THE CORD BEFORE DISASSEMBLING. • Turn the cover clockwise until the safety interlock tab on the cover is disengaged from the safety interlock switch on the chute and the tabs are clear of the tabs on the cover. • Remove the large food pusher from the feed tube. Remove the small pusher from the large pusher. • Remove the continuous-feed chute from the motor base. If the chute is pointing in the 4 o'clock position, just lift it up. If not, rotate clockwise to disengage the tabs on the bottom of the chute platform (motor base) from the slots on the bottom of the continuous-feed chute. • Use caution removing accessory discs as the blades are very sharp. 12