Waring WFP16SCD Instruction Manual - Page 11
Julienne Disc Operation, Troubleshooting
View all Waring WFP16SCD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
JULIENNE DISC OPERATION Waring Commercial offers a julienne disc as an optional accessory. Follow the instructions below to operate. • Prepare all food items to be processed by washing and peeling as required. Remove pits, stones, and large seeds. Be sure the food will fit into the proper feed chute. • If a long horizontal cut is desired - for example, squash sticks - the food must be placed in the feed chute horizontally or on its side. For finely chopped food results - for example, chopped celery or finely chopped onions, you must insert the vegetables vertically or standing up. For a very fine chop of onions, quarter the onion and gravity-feed it through the chute. Removing processed food from the batch bowl 1. Turn the machine off and wait for the blade to stop moving before removing the lid and pusher. 2. If the blade holds the bowl locked when the motor stops, move the handle of the bowl rapidly back and forth - first clockwise, then counterclockwise. 3. If using a disc, remove before tilting the bowl, using a spatula to scrape off any food sticking to it. If using S-blade, it will stay locked in the bowl when you tilt to pour. Use spatula to scrape food out of bowl. NEVER USE FINGERS TO REMOVE FOOD WHILE BLADE IS IN BOWL. TROUBLESHOOTING This section describes potential problems and the correct solutions for them. Problems that cannot be solved with the guidelines listed below should be referred to one of the Waring Authorized Service Centers for assistance. A listing of authorized service agencies is supplied with each Waring food processor. Unit does not start when assembled correctly • Pull the plug and try plugging into another outlet. • Make sure the bowl is properly positioned on the motor base, that the bowl cover is attached properly, and that the safety interlock tab on the cover has properly engaged the safety interlock switch. • Press ON button. 20 Unit stops running during processing • The unit may have overheated. Refer to Resetting Thermal Protection section (page 15). • Turn unit off and unplug. • Remove bowl attachment. • Remove food being processed from inside the bowl and discard. • Allow unit to cool for 30 minutes. • Reassemble unit, and run first with the bowl empty, then put food into the bowl and try again. Unit jams or vibrates excessively • Turn unit off and unplug. • Disassemble the batch bowl/accessories. • Make sure there is no food in S-blade hub (if applicable). • Clean food off accessory discs (if applicable). • Reassemble unit, and run first with the bowl empty, then put food into the bowl and try again. Unit will not come up to full speed • Bowl is overloaded - remove food being processed and reload using smaller quantities. If unit does not operate after you have followed the above • Check outlet to be sure there is current. • Check to be sure circuit breaker is on. • Check to be sure the fuse is not blown if there are fuses on this circuit. • Call a local Waring service agency. If food processor makes grinding noise • Turn unit off, unplug, disassemble, check bowl and blade to see if they have been rubbing together. • If bowl and blade are rubbing, call your authorized Waring service agency. 21