Waring WFP16SCD Instruction Manual - Page 7
Operating The Controls, How To Use, Disassembly Of Continuous- Feed, Chute Parts
View all Waring WFP16SCD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
the unit until the continuous-feed chute is properly assembled with the cover. To remove dicing assembly, first rotate dicing blade counterclockwise and lift up from the edges. Be careful not to touch the blade when removing dicing assembly as the blades are very sharp. Next lift the dicing grid. NOTE: Dicing assembly (WFP16S13) is to be handwashed only. DO NOT PUT DICING BLADE OR GRID IN DISHWASHER. NEVER ATTEMPT TO START THE FOOD PROCESSOR WITHOUT THE CHUTE AND COVER LOCKED INTO POSITION. • Insert the small food pusher into the large food pusher opening. Now you are ready to insert the large pusher into the feed tube opening. • O nce feed chute is assembled, place separate container under the feed chute. DISASSEMBLY OF CONTINUOUS- FEED CHUTE PARTS ALWAYS UNPLUG THE CORD BEFORE DISASSEMBLING. • Turn the cover clockwise until the safety interlock tab on the cover is disengaged from the safety interlock switch on the chute, and the tabs are clear of the tabs on the cover. • Remove the large food pusher from the feed tube. Remove the small pusher from the large pusher. • Remove the continuous-feed chute from the motor base. If the chute is pointing in the 4-o'clock position, just lift it up. If not, rotate clockwise to disengage the tabs on the bottom of the chute platform (motor base) from the slots on the bottom of the continuous-feed chute. • Use caution removing accessory discs as the blades are very sharp. 12 OPERATING THE CONTROLS • Plug the machine into an electrical outlet. The outlet must be 120V, 60Hz. • There are three control buttons on the base unit. The three controls are: ON OFF PULSE How they work: ON: Press the ON button to start the motor. OFF: Press the OFF button to stop the motor. PULSE: To pulse the motor, press the PULSE button down, then release. The motor will run as long as you hold the button down; it stops when you release the button. How to Use Continuous use For continuous processing, use the ON button which is located in the middle. Pulsing • For rapid ON/OFF operation, use the PULSE. The motor runs as long as you hold the button down; it stops when you release the button. • You control the duration of each pulse by the amount of time you hold the button down. You control the frequency of pulses by the rate at which you press the button. • Pulsing gives you greater control over consistancy when chopping, blending and mixing. • Pulsing is also useful in processing hard foods. Pulse the food a few times to break it up into smaller parts. Then proceed with continuous use after the pieces are broken up and easier to process. 13