Weber Genesis 1000 LP Owner Manual - Page 15
Step 11, Step 12
View all Weber Genesis 1000 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Step 11 Add fuel scale assembly You will need: fuel scale assembly, two 1/4-20 wing nuts and two nylon washers. Slip the bolts on the back of the fuel scale assembly through the two small holes in the tank panel. Make sure indicator rod of fuel scale is on the left side of the wheel frame. Add washers then wing nuts and tighten. Figure 13. Step 12 Install igniter Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system. The igniter lock nut is on the igniter. Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 14 (b). Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Figure 14 (c). Tighten the igniter lock nut. Figure 14. Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers. (a) E E F F View from front left View from front right Figure 13 Frame brace (b) Figure 14 Keyhole in Igniter lock nut frame brace (c) Frame brace Small part of keyhole in frame brace 15