Weber Genesis 1000 LP Owner Manual - Page 17
Step 15, Step 16
View all Weber Genesis 1000 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Step 15 Check that all burner valves are off You will need: one burner control knob. Valves are shipped in the OFF position, but you should check to be sure. Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn, they are off, proceed to the next step. Figure 16. Route the hose so it will not interfere with the scale indicator rod. The hose and regulator are connected in the following manner: Slide back the collar of the quick disconnect on the tank valve. Push the male fitting of the regulator into the quick disconnect, and maintain pressure. Slide the collar closed. Figure 18 (a). Figure 18 (b) shows the quick disconnect engaged and various components of the tank and regulator. Regulator vent hole should be at 3, 6, or 9 o'clock. It should not be pointed up. Figure 18 (c). Figure 16 Step 16 Connect LP tank ƽWARNING: Make sure that the LP tank valve is closed. Close by turning clockwise. Hook the LP tank onto the fuel scale. Loosen the tank lock wing nut. Swing the tank lock down. Tighten the wing nut. Figure 17. E Tank lock wing nut F Figure 17 (a) Male fitting Collar Hose Regulator (b) Tank valve Valve handwheel close clockwise Pressure relief valve Regulator vent Quick disconnect engaged Tank (c) Turn so regulator vent does not collect water Figure 18 17