Weber Genesis Jr NG Owner Manual - Page 20

Step 17 Install lid You will need: lid, two hinge pins and two hair pin cotters. Set the lid in place from the rear of the barbecue. Close and align the hinge at the rear. Insert hinge pins from the outside through the hinge. Insert hair pin cotters into the small holes in the hinge pins. Figure 22. Hair pin cotter Step 19 Install swing table You will need: swing table, hinge support, support rod, spacer, rod cover, 10-24 x 1/2 screw, 10-24 nut, star washer, support rod holder and a screwdriver. Push the support rod into the lower support bracket. Figure 24 (a). Slide all the way in, so the rod is inside the locking tab. Figure 24 (b). The rod should swing freely inside the locking tab. Figure 24 (c). Hinge pin Figure 22 Step 18 Install tool holders, control panel and burner knobs You will need: three tool holders, control panel (with control panel push-in buttons) and two burner control knobs. Hook the tool holders over the frame rail. Figure 23. Set the control panel in place over both frame braces. Place your thumbs over the control panel push-in buttons, and push them into the frame brace until they snap into place. Figure 23 (a). Push on the two burner control knobs. Figure 23 (b). Hole in frame brace (a) CD Tool holders Figure 23 Control panel push-in buttons (b) 20 (b) (c) (a) Figure 24