Weber Summit FT 400 LP Owners Manual - Page 16

Step 10 Add tank panel You will need: tank panel assembly, 1/4-20 x 1 3/4 inch bolt, 1/4-20 hex nut, two 1/4 inch nylon washers, pliers, and a 7/16 inch or adjustable wrench. Insert the tank panel tabs into the slots in the wheel frame brace. Slide up until the notch at the bottom of the tank panel fits over the cross brace of wheel frame. Figure 13 (a). Add the washer to the bolt. Put the bolt through panel and cross brace. Add washer and hex nut and tighten with 7/16 inch or adjustable wrench holding the nut with the pliers. Figure 13 (b). Slot in frame brace (a) Step 11 Add fuel scale You will need: fuel scale assembly, two 1/4-20 wing nuts and two nylon washers. Slip the bolts on the back of the fuel scale assembly through the two small holes in the tank panel. Make sure indicator rod of fuel scale is on the left side of the wheel frame. Add washers, then wing nuts and tighten. Figure 14. Tabs on tank panel Wheel frame (b) E E F F View from front left View from front right Figure 14 Cross brace of wheel frame Figure 13 16