Weider 140 User Manual - Page 7
Long Pad Tube 10. Slide the Pad Tubes through - how to use
View all Weider 140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
7. Tap two 19mm Round Inner Caps (9) into each Long Pad Tube (10). Slide the Pad Tubes through 7 4 the holes in the Leg Lever (4). Slide two Long Foam Pads (23) onto each Pad Tube. 23 9 10 9 8. Tap two 25mm Square Inner Caps (35) into each 8 of the two Backrest Tubes (5). Attach each Backrest Tube (5) to the Backrest (6) with two M6 x 38mm Screws (30) and two M6 Washers (26). Note: Do not tighten the Screws yet. 10 23 30 35 26 30 5 26 6 9. Tap a 19mm Round Inner Cap (9) into each end of the Support Rod (7). Insert the Support Rod through a set of holes in the Uprights (1). Rotate the Support Rod to the locked position, with the locking pin wrapped around the Upright. Lubricate the M10 x 135mm Bolt (36). Attach the Backrest Tubes (5) to the welded tube on the Frame (2) with the Bolt, two M10 Washers (34), and an M10 Nylon Locknut (33). Tighten the M6 x 38mm Screws (30) used in step 8, and the Nylon Locknuts (17, 33) used in steps 1-4. 10. Attach the Seat (11) to the brackets on the Frame (2) with four M6 x 16mm Screws (29). 35 9 1 9 36 34 5 2 33 34 Welded Tube 10 11 1 9 7 Locking Pin 2 29 7