Weider 2100 English Manual - Page 13

28. Route the Low Cable (47) through the Seat Upright (73) and under a 90mm Pulley (38). Attach the Pulley inside the Seat Upright with an M10 x 65mm Bolt (59), two M10 Washers (26), two 13mm Spacer (34), and an M10 Nylon Locknut (71). See the inset drawing. Attach the end of the Low Cable (47) to the Leg Lever (4) with an M10 x 28mm Shoulder Bolt (78) and an M10 Nylon Locknut (71). SEAT ASSEMBLY 29. Orient the Seat (16) as shown. Attach the Seat to the Seat Frame (5) with an M6 x 65mm Bolt (65), an M6 Washer (35), and two M6 x 15mm Bolts (66). 28 71 26 4 47 34 73 71 78 29 Wide End 47 16 5 35 65 66 38 34 26 59 30. Attach the Backrest (15) to the Front Upright (6) 30 with two M6 x 65mm Bolts (65), and two M6 Washers (35). 6 35 65 15 35 65 31. Press two 19mm Round Inner Caps (27) into the 31 ends of a Pad Tube (17). Slide the Pad Tube through the hole in the Leg Lever (4). Slide two Foam Pads (18) onto the ends of the Pad Tube. Repeat this step with the other Pad Tube (17) and the Seat Upright (73). 18 17 17 4 27 27 13 73 18