Weider 2100 English Manual - Page 8

9. Press a 40mm x 50mm Inner Cap (23) into the 9 indicated end of the Right Butterfly Arm (11). Wet 62 the bottom end of the Arm with soapy water. Slide 11 a Large Foam Pad (19) onto the Arm. 48 Attach a Pivot Bracket (48) to the Right Butterfly Arm (11) with an M10 x 50mm Bolt (62) and an M10 Nylon Locknut (71). Do not overtighten the Locknut; the Pivot Bracket must be able to 64 pivot easily. 23 71 64 10 Slide a Foam Grip (76) onto the Right Handle 19 (13). Attach the Handle to the Right Butterfly Arm (11) with two M8 x 15mm Bolts (64). Slide the Large Foam Pad (19) down so that the bottom of the Foam Pad is even with the bottom of the Arm. 76 13 Repeat this step with the Left Butterfly Arm (10). 10. Lubricate an M10 x 82mm Bolt (50) and both sides of two Plastic Washers (55) with grease. Attach the Right Butterfly Arm (11) to the Butterfly Frame (9) with the Bolt, the two Plastic Washers, two Butterfly Caps (54), and an M10 Nylon 10 Welded Lubricate Bushing 55 50 11 54 Locknut (71). Do not overtighten the Locknut; the Butterfly Arm must be able to pivot easily. Be sure the indented sides of the Plastic Washers fit over the welded bushing in the Butterfly Arm. 55 9 Lubricate 54 10 71 Repeat this step with the Left Butterfly Arm (10). 11. Press two 40mm x 50mm Inner Caps (23) into 11 the ends of the Leg Lever (4). Lubricate an M10 x 65mm Bolt (59) with grease. Attach the Leg Lever (4) to the Seat Upright (73) with the Bolt and an M10 Nylon Locknut (71). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily. 73 23 71 59 4 Lubricate 23 8